K&G MAKER TOOLS BUILD TEST · V0.5

3D LETTER MAKER

Make It 3D. One letter. All the pieces. No mystery strips.

COIN BANKS + CLEAN FRAMES
Construction prototype

1 Start with your letter

TYPE YOUR LETTER Choose a font Upload your font TTF / OTF Your upload stays in your browser. SVGs contain paths, not font files.

2 Size it up

Finished height inOutside depth in

What are you cutting?

Actual thickness inKerf in

Measure your sheet. Nominal thickness is a filthy liar. Joint fit

3 What are you making?

Light Box and SVG shapes are not included in this build.

Sheet size & construction settings

Sheet width inSheet height in

Maximum wall-strip length in

Tab width inTab spacing in

Flex-cut spacing in Engrave matching IDs on faces Turn face IDs off for a clean front. Wall IDs stay on. Curved regions use narrower tabs. Walls are recessed one material thickness behind the face edges.

Start with scrap. Material bends do not care how good the preview looks.

Preparing your letter...

12 inFinished height2.5 inOutside depth—Wall strips—Cut sheets

INCHES · 100% SCALE

Explode / see inside Lift trim only

Your parts. Actual size. Clean front.

All sheets, tests, assembly notes and settings. Kerf is already applied.

Your cut list

Build a letter to see its parts.

Before you cut

This is a fabrication prototype, not a production-validated pattern. Test fit and bending on your actual sheet first. Use zero additional kerf offset in your laser software.